Frische Luft ohne InsektenEin engmaschiges Gitter auf der Innenseite hindert Plagegeister daran, in den Bus zu gelangen.
Lüften auch bei RegenDie Lamellen an der Außenseite halten Regenwasser außerhalb des Fahrzeugs.
Sichere BefestigungDas Airvent sitzt fest im Schiebefenster und kann nur von innen herausgenommen werden.
This ventilation grille from the Airvent series bridges a gap in the market for all Bulli fans. It was developed by Hülsberg especially for the VW T6.1 and can now finally provide fresh air in your Bulli.The practical slats allow air exchange, while a grid on the inside keeps flies out of the vehicle. To prevent rainwater from running over the edges and into the car, a rubber lip has been added to cover the entire edge of the grille.
You don't have a VW T6.1?If you have a VW T5 or T6, you need a different model in the exclusive version.
Your window is on the right?In this case you need to pick the airvent designed especially for the right-hand side.
What about right-hand drive vehicles?
It doesn't matter where the driver's seat is. You pick the Airvent for the side of the vehicle where the sliding window is.
Not sure yet which side it is? Imagine you sit in your bus, facing the windscreen. Is the sliding window to your left or to your right? Whatever the answer is, that's the Airvent you need.
Mounting of the Airvent
In just a few steps, the Airvent is installed in your bus and can be removed again in just a few simple steps for further travel or to close the window.
- Open the rear seat window on the left side
- Insert the Airvent into the open window from the outside
- Close the window as far as possible. It is no longer possible to close the window completely with the ventilation grille >/li>
- Lock the ventilation grille by tightening the adjusting screws of the grille from inside
And the Airvent is now firmly and securely seated in your bus.
If you want to continue your journey or close the window, simply follow the same steps backwards and remove the airvent in no time.
|Included in delivery||1 x Ventillation Grille for sliding window LEFT|
|Suitable for||Original VW T6.1 sliding window|
Design & Herstellung von Hülsberg aus Remscheid
Von erfahrenen Metallbauern produziert
Über 500 zufriedene Kunden