Frische Luft ohne InsektenEin Gitter auf der Innenseite hindert Plagegeister daran, in den Bus zu gelangen.
Lüften auch bei RegenDie Lamellen an der Außenseite halten Regenwasser außerhalb des Fahrzeugs.
Sichere BefestigungDas Airvent sitzt fest im Schiebefenster und kann nur von innen herausgenommen werden.
The Airvent ventilation grille in the exclusive version from Hülsberg with a rubber lip running all the way around offers fresh air in the vehicle without opening the doors and gates for everyone. At the same time the grille is very stable and can be fixed from the inside. In addition, there is a close-meshed grille on the inside so that no one can reach through the slats from the outside. The Airvent is made of aluminium, so that it is pleasantly light in installation and removal.
What is the difference between Airvent Exclusiv and the normal Airvent?
In the Exclusive version available here, the rubber lip runs completely around the ventilation grille, whereas in the normal version the rubber lip is only present on the upper edge and the upper corners of the air vent. The Exclusive variant offers due to the complete rubber lip a better protection against rainwater entering during windy rainy weather.
On which vehicles does the Airvent - right side fit?
This product fits in the sliding window on the right side of all VW T5 and T6. It does not fit on the VW T6.1. You can find the T6.1 grille in our shop as well.
The sliding window of your bus is left side behind the driver's seat?
Airvent ventilation grilles are also available for.
What about right-hand drive vehicles?
It doesn't matter where the driver's seat is. You pick the Airvent for the side of the vehicle where the sliding window is.
Not sure yet which side it is? Imagine you sit in your bus, facing the windscreen. Is the sliding window to your left or to your right? Whatever the answer is, that's the Airvent you need.
Mounting of the Airvent
In just a few steps, the Airvent is installed in your bus and can be removed again in just a few simple steps for further travel or to close the window.
- Open the rear seat window on the left side
- Insert the Airvent into the open window from the outside
- Close the window as far as possible. It is no longer possible to close the window completely with the ventilation grille >/li>
- Lock the ventilation grille by tightening the adjusting screws of the grille from inside
And the Airvent is now firmly and securely seated in your bus.
If you want to continue your journey or close the window, simply follow the same steps backwards and remove the airvent in no time.
|Dimension||50 x 50 x 5 cm|
|Pack Dimensions||50 cm x 5 cm|
|Included in delivery||1 x Ventillation Grille for sliding window RIGHT|
|Suitable for||Original VW T5 and T6 sliding window|
Design & Herstellung von Hülsberg aus Remscheid
Von erfahrenen Metallbauern produziert
Über 500 zufriedene Kunden